This is the version of the explanation I wish somebody had given me, written down before I forget what confused me. It is about the dosing arithmetic, and it is deliberately narrow — everything I am not confident about is marked as such.
What is actually established
Do it in two steps and it stops being confusing. First concentration: 10mg into 2ml is 5mg/ml. Then volume: a 0.5mg dose is 0.5 ÷ 5 = 0.1ml. Then units, and this is where people go wrong — a U-100 syringe is graduated in hundredths of a millilitre, so 0.1ml is 10 units. The word "units" has nothing to do with milligrams; it is a volume marking that exists because insulin happens to come at 100 units per ml.
The condition it depends on
It is worth saying that rounding to the nearest whole unit is usually acceptable at maintenance doses and is not acceptable at the bottom of a ladder, where one unit can be a fifth of the intended dose.
The practical version
The three numbers to write on the vial: total mg, total ml, and mg per ml. Everything else is division. And the sanity check is that dose volume times number of doses should be less than the volume you put in, because dead space takes the difference.
What I am not sure about
The bit I cannot resolve on my own is how much material I am losing to dead space, and whether that explains why a 10mg vial gives me nine usable draws rather than ten. I have searched first, so if this is covered somewhere point me at it and I will read it.
nancy_portland said:Do it in two steps and it stops being confusing.
Agreeing with nancy_portland, and the qualification matters more than the agreement. Concentration choice is a precision decision, not a preference. Reconstitute high and every dose is a tiny volume where one unit of syringe error is a large fraction of the dose. Reconstitute low and you get more graduations per dose, so the same hand tremor costs proportionally less. Against that, more diluent means more benzyl alcohol and a shorter comfortable in-use window.
Ask again with the specifics and you will get a better answer than this one.
nancy_portland said:Do it in two steps and it stops being confusing.
I am going to disagree with reconstituting low as a general rule. More diluent, more punctures, more in-use days at room temperature, and the stability trade-off is real. Precision is not the only variable being optimised.
Janoshik Analytical — Independent Testing
Trusted third-party HPLC & mass spectrometry analysis. Verify peptide purity with the lab the community relies on. Independent. Accurate. Transparent.
Verify Your PeptidesGL Biochem (Shanghai) Ltd. — Direct Manufacturer
Est. 1998. The synthesis house behind the vials you send for testing. ISO 9001 and cGMP certified, 1,500+ staff, batch-specific COA with every order.
Browse GL BiochemTaking the question as asked, rather than the general version of it. Dead space is the answer to the missing dose. A fixed-needle insulin syringe holds a few microlitres in the hub and needle after the plunger bottoms out, and on small draws that is a measurable percentage of every dose. Across ten draws it adds up to most of an eleventh, which is exactly the "nine draws from a ten-dose vial" complaint. Luer-lock syringes are worse; low-dead-space fixed-needle designs are better.
TirzTom said:Concentration choice is a precision decision, not a preference.
Same position here, arrived at the long way round. Worth adding the genuine exception, because it is real and narrow: a change made for an identified patient where the prescriber determines it produces a significant clinical difference for that patient. A grid of fixed doses offered to everybody is not that, whatever the intake form says.